Additional Information
FastTrack Essentials product assembly comes with the following components fully assembled. All SkyView Network-equipped components are pre-connected and are ready to be connected to a display (SV-EMS-220, SV-ARINC-429, and SV-NET-HUB). The SV-ADSB-472 comes mounted but unwired.
FastTrack Essentials VFR:
- Universal Module Mounting Tray for SV-HDX1100
- SV-EMS-220 EMS Module
- SV-ADSB-472 ADS-B In Receiver Module
- SV-NET-HUB SkyView Network Hub
- SV-NET-XinCC SkyView Network Cables
- SkyView Display Harness
- ADS-B Receiver Harness Kit
FastTrack Essentials IFR:
- Universal Module Mounting Tray
- SV-EMS-220 EMS Module
- SV-ARINC-429 Module
- SV-ADSB-472 ADS-B In Receiver Module
- EMS to ADAHRS/ARINC Module Stacking Kit
- SV-NET-HUB SkyView Network Hub
- SV-NET-XinCC SkyView Network Cables
- SkyView Display Harness
- ADS-B Receiver Harness Kit
ADAHRS Mounting Notes
Although the Universal Module Mounting Tray for SV-HDX1100 can accommodate SkyView ADAHRS modules, many installers will mount ADAHRS modules elsewhere in the aircraft due to the following:
- Installing an ADAHRS module using the Universal Module Mounting Tray will require installing an SV-MAG-236 Remote Magnetometer elsewhere in the aircraft because there will be too much electromagnetic interference in the area for adequate magnetic heading sensing performance.
- An ADAHRS module must be mounted within one degree of parallel to all three aircraft axes. This may not be possible in aircraft where the panel has tilt relative to the pitch axis of the aircraft.
- Some homebuilt aircraft instrument panels are subject to significant vibration because they are close to the engine. Vibration can adversely impact an ADAHRS module’s performance.
Refer to the SV-ADAHRS-220/221 Installation and Configuration section of the SkyView System Installation Guide for additional guidance on mounting an ADAHRS module.
Proudly built in the U.S.A.